Honda NSS300 Forza - Owner's Manual > Battery Goes Dead
Charge the battery using a motorcycle battery charger.
Remove the battery from the scooter while charging.
Do not use an automobile-type battery charger, as these can overheat a scooter battery and cause permanent damage.
If the battery does not recover after recharging, contact your dealer.
NOTICE Jump starting using an automobile battery is not recommended, as this can damage your scooter's electrical system.
Burned-out Light Bulb
Follow the procedure below to replace a burned-out light bulb.
Turn the ignition switch to the OFF or LOCK position.
Allow the bulb to cool before replacing it.
Do not use bulbs other than those specified.
Check the replacement bulb for correct operation before riding.
For the light bulb wattage, see "Specifications".
Headlight Bulb
1. Pull the socket off the bulb without turning it.
2. Remove the dust cover.
3. Press the pin down and pull out the bulb without turning it.
4. Install a new bulb and parts in the reverse order of removal.
Do not touch the glass surface with your fingers. If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol.
Brake/Rear Turn Signal Bulb
1. Open the seat.
2. Remove the document compartment.
3. Remove the clips.
4. Remove the tool box.
Brake Light Bulb
5. Turn the socket counterclockwise and pull it out.
6. Pull out the bulb without turning it.
7. Install a new bulb and parts in the reverse order of removal.
Rear Turn Signal Bulb
5. Turn the socket counterclockwise and pull it out.
6. Slightly press the bulb in and turn it counterclockwise.
7. Install a new bulb and parts in the reverse order of removal.
- Use only the amber bulb for the rear turn signal bulb.
Tail Light Bulb
1. Remove the screws.
2. Release the tabs A from the slot by pulling the rear body lower cover.
- Carefully release the tabs.
3. Release the tab B and hook A by pulling the rear body lower cover diagonally backward.
4. Turn the socket counterclockwise and pull it out.
5. Pull out the bulb without turning it.
6. Install a new bulb and parts in the reverse order of removal.
Front Turn Signal Bulb
1. Open the left/right fairing pocket.
2. Remove the screws.
3. Remove the left/right front panel.
4. Turn the socket counterclockwise and pull it out.
5. Slightly press the bulb in and turn it counterclockwise.
6. Install a new bulb and parts in the reverse order of removal.
License Plate Light Bulb
1. Remove the screws and license light cover.
2. Pull out the bulb without turning it.
3. Install a new bulb and parts in the reverse order of removal.
See also:
Honda NSS300 Forza - Owner's Manual > Blown Fuse
Before handling fuses, see "Inspecting and Replacing Fuses". Fuse Box 1 Fuses & Main Fuse 1 (NSS300A)