Peugeot Satelis - Service manual > Numeric functions (multifunctional display)

1. The tripmeter.
2. Daily odometer.
3. Fuel gauge.
4. Digital clock.
5. Outside temperature gauge.
6. Engine temperature gauge.
7. Battery voltage fault.
8. Maintenance indicator.
9. Empty tank indicator light.

Tripmeter.

The tripmeter displays and stores the number of kilometres travelled by the vehicle.

The machine total kilometres remains in the memory when the battery is disconnected.

Changing the distance unit (km or miles) is as follows

• The ignition is switched off, press the control button while switching on the ignition, the distance unit will flash.
• Select the unit by briefly pressing the control button, the distance unit changes from "km" to "miles" or inversely.
• Switch off ignition to confirm.

If the distance unit is kilometres, the outside temperature is displayed in ºC.

If the distance unit is miles, the outside temperature is displayed in ºF.

Daily odometer.

The tripmeter displays and stores the number of kilometers travelled during a given period.

The daily odometer uses the same unit of measurement as the tripmeter.

Resetting the daily odometer:

• Press the control button (several times briefly) until the figures of the daily odometer flash.
• Pressing the control button for more than 3 s allows you to reset the daily odometer.

Fuel gauge.

In the fuel reserve position, the two last segments are lit and flash.

When the fuel tank is empty, all segments are off and the pump flashes.

Fuel gauge self-diagnostic All segments flash if the fuel gauge or its wiring is faulty. Open circuit (wire cut).

Digital clock.

Time setting:

Press the control button (several times briefly) until the figures of the clock flash.

Pressing the control button for more than 3 s make the the time characters flash.

Set the time by successive pushes on the control button.

Pressing the control button for more than 3 s will make the first character of the minutes flash.

Set the time by successive pushes on the control button.

Pressing the control button for more than 3 s will make the second characters of the minutes flash.

Set the time by successive pushes on the control button.

Pressing the control button for more than 3 s will allow you to confirm the time.

Outside temperature gauge

If the distance unit is kilometres, the outside temperature is displayed in ºC.

If the distance unit is miles, the outside temperature is displayed in ºF.

Engine temperature gauge.

Vehicle with Magneti Marelli ECU: the engine temperature sensor controls the temperature gauge.

When the engine temperature is too high, all segments are switched on and the last flashes.

Temperature alarm. On the basic instrument panel, the stop warning light is on.

If the temperature information does not reach the instrument panel, all segments flash. Open circuit (wire cut).

Battery voltage fault.

The battery charge warning light flashes if the battery voltage goes below 11.2 volts and it stops flashing when the voltage passes again above 11.7 volts.

The battery charge warning light flashes and the stop warning light comes on (only basic instrument panel version) when the battery voltage is below 16 volts.

Maintenance indicator.

Maintenance function: The maintenance indicator goes on 5000 kms after the last reset.

Maintenance reset:

• The ignition is switched off, press the control button while switching on the ignition, the distance unit will flash.
• Pressing the control button for more than 5s allows you to reset the maintenance indicator, and the "key" icon will go off.

See also: