Kymco XCITING 500 - Service Manual > Lights/Meters/Switches
See also:
Kymco XCITING 500 - Service Manual > Electric Starter
STARTING SYSTEM LAYOUT STARTING CIRCUIT
Kymco XCITING 500 - Service Manual > Service Information
SERVICE INFORMATION GENERAL A halogen head light bulb becomes very hot while the head light is on, and remains for a while after it is turned off. Be sure to let it cool down before servicing. Note the following when replacing the halogen headlight bulb Wear clean gloves while replacing the bulb. Do not put finger prints on the headlight bulb, as they may create hot spots on the bulb and cause it to fail. If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent its early failure. Be sure to install the dust cover after replacing the bulb. Check the battery condition before performing any inspection that requires proper battery voltage. A continuity test can be made with the switches installed on the scooter. Route the wires and cables properly after servicing each component.
