Kymco XCITING 500 - Service Manual > Engine hanger
REMOVAL
Loosen and remove the engine mount nut.
Loosen and remove the engine mount bolt.
Remove the engine hanger mount bolts and outer collars.
Remove the engine hanger and inner collars.
Remove the nut, washers, rubber washers and engine hanger rod.
INSTALLATION
Installation is in the reverse order of removal.
Torque:
Engine hanger mounting bolt: 50 N*m (5 kgf*m, 36 lbf*ft)
Engine hanger rod nut: 35 N*m (3.5 kgf*m, 25 lbf*ft)
INSPECTION
Inspect the bearing: Bearings allow play in the engine hanger or the bearing turns roughly → Replace.
Inspect the bush: Wear/Damage → Replace.
See also:
Kymco XCITING 500 - Service Manual > Service information
GENERAL INSTRUCTIONS During engine removal and installation, support the scooter on its main stand. Support the frame using a jack or other adjustable support to ease of engine hanger bolt removal. The following components require engine removal for serviced with the engine installed in the frame. Oil pump (Section 4) Water pump (Section 6) Cylinder head (Section 8) Cylinder/Piston (Section 9) Drive and driven pulleys/clutch (Section 10) Final reduction (Section 11) Alternator/Starter clutch (Section 12) The following components require engine removal for service. Crankshaft/Crankcase/Balancer (Section 13)
