Peugeot Satelis - Owner's Manual > Display functions

1. Milometer.

The machine total kilometres remains in the memory when the battery is disconnected. The machine total kilometres remains in the memory when the battery is disconnected.

2. Tripmeter. (TRIP)

The tripmeter displays and stores the number of kilometers travelled during a given period.

Resetting the tripmeter

Resetting the tripmeter is done from the TRIP position.

• Press the control button (several times briefly) until the figures of the daily odometer flash.
• Press the control button (1) for more than 3 seconds to reset the daily tripmeter.

3. Setting the clock

• Press the control button (several times briefly) until the figures of the clock flash.
• Pressing the control button (1) for more than 3 seconds will make the two hour digits flash.

• Set the time by successive pushes on the control button.

Pressing the control button for more than 3 seconds will make the first digit of the minutes flash.

• Change the minutes by successive pushes on the control button.

Pressing the control button for more than 3 seconds will make the second digit of the minutes flash.

• Change the minutes by successive pushes on the control button.
• Press the control button for more than 3 seconds to confirm the clock setting.

4. Fuel gauge.

   Fuel reserve gauge.

When the fuel tank is full all the segments of the fuel gauge are lit.

The fuel reserve gauge corresponds to the two last segments (E) which show two reserve levels.

1st level: the first two segments flash.

2nd level: the last segment flashes.

When the tank is empty, all the segments are off and the pump (F) flashes.

7. Engine temperature gauge

When the engine temperature is too high, all segments are switched on and the last flashes. (H)

Safe mode will be activated. You are advised to switch off the engine and check the level of coolant after it has cooled d own..

You are advised to have the vehicle checked by an authorised dealer.

9. Maintenance indicator

The maintenance indicator goes on 5000 kms after the last reset.

You are advised to go to an authorised dealer to have the vehicle serviced and the message on the maintenance indicator erased.

10. Battery charge warning light

If the indicator light turns on when riding, you are advised to have the vehicle checked by an authorised dealer. If the indicator light comes on at idling speed, this is normal.

11. Outside temperature gauge

The temperature shown is that read on the front of the vehicle.

CONTROLS

1. Horn switch
2. Light flashing button
3. Dipped lights/Headlights switch

The dipped lights/headlights switch has 2 functions:

1. High beam

In the high beam position, both dip beam and high beam are on simultaneously. (except for Compressor)

2. Dip beam

The headlight stays on while the vehicle is moving, even if the engine has stalled and stays on for 7 seconds after the vehicle stops. The headlight stays on for 3 seconds after the ignition is switched off with the vehicle stopped.

4. Indicators switch

To indicate a change of direction, press the switch (4) :

• Either to the right.
• Or to the left.

To stop the indicators flashing, press the switch. (4)

5. Starter switch
6. Emergency stop button

This feature is used to stop the engine in case of emergency. This button must not be used to switch off the engine on a regular basis.

4. Engine off position
5. Start-up position

7. Hazard warning light switch

The hazard warning lights only work with the ignition key in the "ON" position.

The hazard warning lights are switched off automatically 1 hour after the ignition was switched off, to perserve the battery.

See also: